Cleaning
Guidelines
The pools are fabricated from a high impact weatherable
ABS plastic. We have carefully chosen this material rather than GRP fibreglass
for the shell. Because it’s harder surface is less brittle.
It’s more resistant to bacteria and not affected by
the repeated use of sterilising agents. The material has a lightly textured,
slip resistant internal finish and a smooth, clean external finish.
- Before filling the pool rinse it out with cold water and run the
taps for two minutes.
- After use the pool must be cleaned with warm water and a non-abrasive
detergent.
- Disinfect the pool using either 24 x 0.5 gms or 5 x 2.5 gms Presept
Tabs to 3 x 10 lt.. buckets of water.
- Alternatively fill the pool and add presept tabs to the same strength
as above.
- Both of these methods will provide a solution of 1000ppm Sodium Dichloroisocy.
- Leave solutions in the pool for 10 minutes ensuring all surfaces
are wiped over
- The drainage outlet should be paid particular attention and cleaned
with a disposable cloth.
- The pool should then be emptied of the solution and rinsed with cold
water and dried.
- The drainage outlet pipe should be kept closed when not in use.
- The pool should be cleaned daily with warm water and a non-abrasive
detergent.
|
